Qisheng Machinery mainly develops and produces automatic palletizing systems for bricks, which are closely related to brick making machines. Today we will share the environmental protection brick machine:

What are the precautions for turning waste into treasure in the production of environmentally friendly brick machines?

The environmental protection brick machine turns construction waste, fly ash, tailings, etc. into treasures, and produces environmental protection bricks for the real estate industry and urbanization construction. develop. Since the environmental protection brick machine is a high-tech new product, which is different from the traditional brick machine equipment, we need to have certain skills and professional knowledge. In order to make the production go on normally, we will introduce in detail what should be paid attention to in the production of the environmental protection brick machine ?

1. The storage hopper of the environmental protection brick machine is easy to condense into blocks because the material is easy to condense into blocks. Before leaving work, the mixture in the storage silo should be used up or cleaned up directly; attention should be paid to feeding and distributing materials, and there should be no large-size aggregates in the mixer or other foreign matter mixed in, especially solid objects such as iron pieces, can easily damage the machine;

2. The bottom plate of the material distribution system should be kept on the same plane as the mold. After a period of use, it should be checked and adjusted. After the material distribution device is returned, it can not only scrape back the remaining material, but also clean up the excess mixture on the surface of the upper pressure head. Scrape up and down The board should be adjusted well, and it should be replaced in time if excessive wear occurs;

3. The pressure of the hydraulic system should be adjusted, and the rated pressure should not be exceeded. The oil filter should be cleaned or replaced regularly, and the hydraulic oil should be filtered every six months. Always check whether the oil in the oil tank is sufficient. If it is too little, it should be replenished; the slider and the column are excessively worn To replace the copper sleeve and dust seal, ensure that the gap between the mold box and the four sides of the indenter is roughly even, and the demoulding is stable;

4. During the working process of the environmental protection brick machine, it is not allowed to adjust the mold or limit switch at will, and it is not allowed to perform welding operations. If adjustments are required, it should be stopped before proceeding;

5. Carefully observe the working conditions of the environmental protection brick machine during the working process. If there is noise or abnormality, stop the machine for inspection and then carry out maintenance;

6. Before going to work, check the fastening screws of the oil cylinder, mold, motor and other parts for looseness, and tighten them to avoid loosening during work;

7. Before leaving get off work, the excess mixture in the mold should be cleaned out, and the mold should be cleaned and maintained to prevent it from rusting;

8. It is also necessary to maintain the column regularly to prevent it from rusting or wearing;

9. Put all the tools in a good place, and turn off the power after the equipment checks that there is no fault.

The precautions in the production process of the environmental protection brick machine summarized above can help us better use the environmental protection brick machine, improve its performance and reduce the failure rate of equipment.